Holybro Kakute F7 V1.5 Flight Controller +Tekko32 F3 40A 4 In 1 Blheli 32 3-6S Brushless ESC for RC Drone
The Holybro Kakute F7 flight controller makes it easy to build your multirotor. It integrates flight
IMU upgraded to MPU6000,Re-designed and more reliable damping structure.
Kakute F7 V1.5
Kakute F7 V1.5
• MCU: STM32F745 32-bit processor
• Barometer: BMP280
• USB VCP Driver (all UARTs usable simultaneously; USB does not take up a UART)
• All UARTS support hardware inversion. SBUS, SmartPort, and other inverted protocols work on
• Supports serial receivers (SBUS, iBus, Spektrum, Crossfire) only. PPM and PWM receivers are not
• TF card for Blackbox logging
• Mounting Holes: Standard 30.5mm square to center of holes
Features:
• Betaflight OSD. Change PIDs, adjust common configuration parameters, and change video
• Soft-mounting built in. The IMU (“gyroâ€) chip on this board is mounted on vibration-isolating
• High-performance / low-noise / high sensitivity IMU. MPU6000 with 6-axis gyro and
• Ready for autonomous flight: Integrated BMP280 barometer and SCL/SDA pads for use with
• Dedicated bootloader button for easy firmware flashing.
• Input voltage 7v to 42v. Power the board directly from the flight pack, up to 6S (on “B+†pad
• Automatic voltage monitoring. No need to run a separate vBat wire for voltage monitoring; the
• Filtered voltage output for clean, noise-free video. On-board regulators output 5v at up to 2
camera, or LED strip.
New BLHELI32 ESC with F3 MCU, give more smooth control and faster
Features:
âš« Supports 3-6S lipo input
âš« Voltage output (VBAT)
âš« Supports oneshot / Multishot / Dshot PWM
âš« Supports damped light
âš« Extra Cap needed for high current or 6s usage
âš« Weight: 11.6g
Tekko32 F3 4in1 40A ESC *1
8pin to 8pin 1mm pitch 65mm cable *1
